turbine rotor

英 [ˈtɜːbaɪn ˈrəʊtə(r)] 美 [ˈtɜːrbaɪn ˈroʊtər]

网络  透平工作轮; 涡轮机转子

化学



双语例句

  1. The strength and service life verification tests of a newly designed third stage turbine rotor and disc of Type A and Type A-1 engine
    甲型和甲-Ⅰ型发动机全新设计的第Ⅲ级涡轮转子及涡***强度与寿命考核试验圆盘平直涡轮式搅拌器
  2. Application of Immune Algorithm in the Low-cycle Fatigue Crack Growth Rate of Steam Turbine Rotor
    免疫算法在汽轮机转子低周疲劳裂纹扩展速率中的应用
  3. For the design of a particular model of turbine rotor disc, the MDO system for turbine disk and blade is built.
    针对某型号发动机涡轮转子盘片结构,设计开发了涡***片多学科设计优化系统;
  4. Structural analysis and lamination optimum design of wind turbine rotor blade
    风力机叶片的结构分析与铺层优化设计
  5. This paper takes a type gas turbine rotor as an example to analyze its natural frequency and modal shape.
    介绍了某型燃气轮机转子模态试验,试验测得转子静态固有频率和模态振型。
  6. Cause Analysis of Turbine Rotor's Shaft Neck Damage and the Repair
    汽轮机转子轴颈损伤原因分析及修复措施
  7. State Simulation and Fault Diagnosis of Steam Turbine Rotor's Temperature Field
    汽轮机转子温度场的状态仿真及其故障诊断
  8. Study on the Influence of Age and Stress Relaxation on Creep-fatigue Interaction Life of Steam Turbine Rotor Steel
    老化和应力松弛对汽轮机转子钢蠕变疲劳交互作用寿命影响的研究
  9. Diagnosis and Disposal of Vibration Fault Caused by Oil Entering Steam Turbine Rotor Center Bore
    一起汽轮机转子中心孔进油的振动故障诊断与处理
  10. The coupling vibration behaviors of a particular turbine rotor have been analyzed.
    本文分析研究了特型涡轮转子多重耦合振动系统的固有特性。
  11. The Research on Low-cycle Fatigue Crack Growth Rate of Steam Turbine Rotor Steel Based on Immune-Genetic Algorithm
    基于免疫遗传算法的汽轮机转子钢低周疲劳裂纹扩展速率研究
  12. A dynamic strain gage is developed for dynamic stress test at900 ℃ of turbine rotor blades of an aeroengine.
    为了对某型航空发动机涡轮转子叶片在900℃温下进行动应力测试,研制了900℃态应变计。
  13. Analysis of Static Strength and Fatigue Reliability of High-Pressure Turbine Rotor System
    某高压涡轮转子系统静强度及疲劳可靠性分析
  14. A commercial N-S solver has been employed for simulation and investigation of the unsteady flow field inside the tip clearance of a turbine rotor.
    商用NS求解器已经被用于透平动叶顶部空隙的非定常流场的模拟和研究。
  15. Study on Numerical Model for Welding Process of Steam Turbine Rotor Based on Three-Dimensional Finite Element Method
    汽轮机转子焊接的三维有限元数值模型研究
  16. Vibration Analysis of Turbine Rotor System under Alford and Oil-film Forces
    汽流和油膜作用下的汽轮机转子振动特性研究
  17. Turbine Rotor Vibration Fault Diagnosis Based on Wavelet Packet Analysis and Lyapunov Exponent
    基于小波包分析及Lyapunov指数的汽轮机转子振动故障诊断
  18. Modeling research on FM forging process of heavy low-pressure turbine rotor
    大型低压转子FM法锻造工艺模拟研究
  19. An engineering example of marine gas turbine rotor is applied to the verification of the provided model.
    文中给出了一个验证性算例和一个工程实例。
  20. Simulation Analysis of Vibration Characteristic of Steam Turbine Rotor under Fault Condition
    汽轮机转子故障状态下的振动仿真分析
  21. Analysing and Treating Friction Losses on Parts of the Second-Row Shroud-Ring in the Curtis Stage of a Turbine Rotor
    汽轮机转子复速级第二列围带局部磨损分析及处理
  22. Strength and Reliability Analysis of Connecting Components of a Turbine Rotor
    汽轮机转子连接件强度及可靠性分析
  23. Discussion on Maintenance Technology of Center Hole of 300 MW Steam Turbine Rotor
    300MW汽轮机转子中心孔检修工艺探讨
  24. Research on Wind Turbine Rotor Turnover Equipment and Installation Technology
    海上风机叶轮翻转机具及安装工艺的研究
  25. These methods are compared, and the method based on blade element theory is selected in modeling of wind turbine rotor.
    通过对这两种方法的比较,选用基于叶素理论的方法建立了风轮模型。
  26. Using potentiostatic pulse technique ( PPT), the sensitization of steam turbine rotor stainless steel was detected in this paper.
    采用恒电位脉冲技术对转子钢的敏化进行检测,并与传统的动电位阳极极化法进行了比较。
  27. Main Design Parameters of Wind Turbine Rotor
    风力发电机组风轮的主要设计参数探讨
  28. It is pointed out that the turbine rotor bearing system design should be knowledge-based design.
    阐述了汽轮发动组转子轴承系统的摩擦学设计应当是基于知识的设计。
  29. A study of creep fracture for a steam turbine rotor material is presented in this paper.
    本文对汽轮机转子材料进行了蠕变断裂的试验研究。